Nous vous avons envoyé un message électronique.

Nous sommes désolés mais nous n'avons pas pu vous envoyer le lien sur votre courriel. Veuillez vérifier votre adresse électronique.

Aide contextuelle




In the frame "Dimensioning", it is possible to display an envelope of internal forces and displacements from all analyses (stages of constructions). Normally, the envelope is constructed from the results of all construction stages, however, it can only be created from the selected stages. The "Modify" button opens the dialog window "Construction stage selection", where it is possible to select the constructions stages that are used to generate the current envelope (by pressing corresponding buttons).

The maximum values of calculated internal forces (bending moments and shear forces) and the magnitude of displacement are displayed at the bottom part of the frame.

The program allows to dimension reinforced concrete, steel and timber cross-sections (by checking the option "Check cross-section").

When checking the cross-section, it is possible to input the reduction coefficient of bearing capacity, which reduces the overall bearing capacity of a cross-section. When performing the analysis with the reduction of earth pressures this coefficient should be considered 1.0. For analysis without earth pressures reduction (to ensure a realistic behavior of a sheeting structure), it is necessary to increase the calculated forces, by adopting a coefficient greater than 1.0 (For EN 1997 is the value in interval 1.35-1.5).

For dimensioning of steel cross-sections, it is possible to assume influence of normal force in these ways:

  • normal forces - do not consider: program doesn't consider influence of normal force.
  • normal forces - from nearest anchor: program assumes maximum value of local normal force near the anchor as N = F*sin α, where α represents slope of the anchor
  • normal forces - sum of all anchors: program adds influence of normal force from input anchors as the sum of influence of all anchors.
  • normal forces - input: user-defined value of normal force N

The frame allows to perform a larger number of analyses pro dimensioning of a cross-section. The "In detail" button at the right part of the frame opens the "Dimensioning" dialog window to show detailed results.

Frame "Dimensioning"