The maximum bearing capacity of a single pile based on the values of tip resistance qc of the ith cone penetration test is given by:
maximum bearing capacity of the pile from ith CPT
maximum base resistance from ith CPT
maximum shaft resistance from ith CPT
If performing the analysis according to the factor of safety or the limit states theory, the bearing capacity of a single pile is obtained as an arithmetic average of n calculated bearing capacities:
If performing the analysis according to EN 1997-2, final bearing capacity ξ3 and ξ4.
If performing the analysis according to the NEN 6743 standard then the approach for more CPTs is different and follows directly the NEN 6743 standard (article 18.104.22.168).
The maximum pile base resistance Fmax,base is provided by:
pile base cross-sectional area
maximum pressure at pile base from CPT results
The maximum shaft resistance Fmax,shaft is provided by:
pile periphery in bearing soil
maximum force on shaft (friction) from CPT results
pile length, either length of actived shaft friction or length of expanded base
vertical dimension alog pile axis
Actual calculation of the maximum pressure at pile base pmax,base and the maximum force developed along the shaft pmax,shaft (determined according to the selected type of analysis selected in the " " tab).