GEO5 Logiciel

Aide contextuelle

Tree
Settings
Program:
Langue:

Verification of Rectangular RC Cross Section

The cross-section is rectangular, unilaterally reinforced, and loaded by the bending moment and normal compression force. The program verifies a reinforced concrete section using the method of limit deformation. The maximum allowable strain of concrete in compression is 0,002 - 0,0035. Compression reinforcement is not taken into account. Minimum eccentricity is applied:

The computed degree of reinforcement is checked using the following expressions:

where:

- for  fy = 460 N/mm2

- for  fy = 250 N/mm2

Interaction diagram N-M

Usage ratio of concrete cross-section subject to the combination of bending moment and normal force is determined as |0L| / |0R|. Where L is load and R is strength with prescribed eccentricity.

Bending without normal force

The cross-section is rectangular, reinforced on one side, and loaded by the bending moment Mu.

The permissible moment for a given area of reinforcements As reads:

The program further checks whether the location of the neutral axis x is less than the limit location of neutral axis xmax given by:

Shear

First, the program computes the ultimate shear strength of concrete Vc.

where:

The νc values are for fcu above 25 N/mm2 multiplied by  (fcu / 25)1/3

If the ultimate shear strength of concrete is exceeded, the ultimate shear strength Vmax is checked.

Next, the necessary reinforcement area is given by:

where:

Essayez GEO5 gratuitement.