Nous vous avons envoyé un message électronique.

Nous sommes désolés mais nous n'avons pas pu vous envoyer le lien sur votre courriel. Veuillez vérifier votre adresse électronique.

Aide contextuelle

GEO5

Tree
Settings
Produit:
Program:
Langue:

Verification of Rectangular RC Cross-Section

The cross-section is rectangular, unilaterally reinforced and loaded by the bending moment and normal compression force. The program verifies a reinforced concrete section using the method of limit deformation. The maximum allowable strain of concrete in compression is 0,002 - 0,0035. Compression reinforcement is not taken into account. Minimum eccentricity is applied:

The computed degree of reinforcement is checked using the following expressions:

Interaction diagram N-M

Usage ratio of concrete cross-section subject to the combination of bending moment and normal force is determined as |0L| / |0R|. Where L is load and R is strength with prescribed excentricity.

Bending without normal force

The cross-section is rectangular, reinforced on one side and loaded by the bending moment M.

The permissible moment for a given area of reinforcements As reads:

The program further checks whether the location of neutral axis x is less than the limit location of neutral axis xmax given by:

- for steel Fe 250

- for steel Fe 400

- for steel Fe 500

Shear

First, the program computes the ultimate shear strength of concrete Vuc.

where: τc is determined according to table 19 standard IS 456 : 2000.

If the ultimate shear strength of concrete is exceeded, the ultimate shear strength Vuc,max is checked.

where: τc,max is determined according to table 20 standard IS 456 : 2000.

Next, the necessary reinforcement area is given by:

where: