Nous vous avons envoyé un message électronique.

Nous sommes désolés mais nous n'avons pas pu vous envoyer le lien sur votre courriel. Veuillez vérifier votre adresse électronique.

Aide contextuelle



Anti-Slide Piles

The "Anti-slide piles" frame contains a table with a list of input piles. Piles are input one of two ways (the "Add in dialog" or "Add graphically" button).

The "New pile", or "Modify pile properties" dialog window serves to input the location of pile (coordinates x, z, length of pile l and spacing between piles b).

The "Locate to the terrain" button places the starting point of pile head on the ground surface. Sometimes, an anti-slide pile can be located in mass directly (in this case it's possible to analyze slope stability, but it's not possible to run the "Anti-Slide Pile" program).

Then it's specified the cross section of pile (circle - diameter of pile d, rectangle - dimensions sx, sy) and the parameters of pile - distribution of bearing capacity along the pile length (linear, constant), maximum bearing capacity Vu, gradient K and direction of passive force (prependicular to the pile, parallel to slip surface). All input parameters can be modified in the stage of construction, in which the anti-slide pile was introduced. In subsequent stages the anti-slide pile can only be removed.

Influence of anti-slide piles on the assessment of slope stability is described in more detail in the theoretical part of the help. Other calculations of the anti-slide piles (analysis of an internal forces, dimensioning of reinforcement of piles) are based on the analysis of active and passive forces in the "Anti-Slide Pile" program.

Frame "Anti-slde piles"

Essayez GEO5 gratuitement sans limitation des calculs.