Nous vous avons envoyé un message électronique.

Nous sommes désolés mais nous n'avons pas pu vous envoyer le lien sur votre courriel. Veuillez vérifier votre adresse électronique.

Aide contextuelle

GEO5

Tree
Settings
Produit:
Program:
Langue:

Analysis

The "Analysis" frame serves to verify the vertical bearing capacity and settlement of a footing. More computations can be performed in the frame. The verification can be performed either for individual loads or the program finds the most critical one (can be selected from a combo list).

For both limit states (strength, usability) program assesses the eccentricity of the foundation. The value of the maximum allowable eccentricity of foundation is entered in the left part of frame.

The analysis is performed according to the selected type of field tests in the frame "Settings", where analysis type is also chosen in the case of using CPT tests.

The analysis can be performed for the worst field test, the average from all tests or selected test from a combo list.

Further it is necessary to enter a safety factor for bearing capacity. It is recommended to use a SF = 3 for all methods using CPTs, SPTs or PMTs.

The stress in the footing bottom used for settlement analysis can be reduced by the geostatic stress given by:

  • original ground
  • finished grade
  • not specified

In the case of inclined footing bottom or analysis according to the Schmertmann method it is also necessary to enter an angle of internal friction φ in the footing bottom.

When calculating bearing capacity from the SPT tests (Meyerhof method), the correlation for saturated fine or silty sands can be used.

Detailed listing of the results is displayed in the right part of the desktop. Visualization of results can be adjusted in the frame "Drawing Settings".

Frame "Bearing capacity"

Essayez GEO5 gratuitement sans limitation des calculs.